Honda 2004 Odyssey Service Manual page 128

12. With a hammer and special tools, install a new
front bearing in the drive end housing.
07749-0010000
07746-0010300
Alternator Brush Inspection
13. Measure the length of both brushes (A) with vernier
calipers (B).
• If either brush is shorter than the service limit,
replace the brush holder assembly.
• If the brush length is OK, go to step 14.
Alternator Brush Length
Standard (New): 10.5 mm (0.41 in.)
Service Limit: 1.5 mm (0.06 in.)
B
Rotor Slip Ring Test
14. Check that there is continuity between the slip rings
(A).
• If there is continuity, go to step 15.
• If there is no continuity, replace the rotor
assembly.
A
15. Check that there is no continuity between each slip
ring and the rotor (B) and the rotor shaft (C).
• If there is no continuity, replace the rear housing
assembly, and go to step 16.
• If there is continuity, replace the rotor assembly.
16. Reassemble the alternator in reverse order of
disassembly, and note these items:
• Be careful not to get any grease or oil on the slip
rings.
• If you removed the pulley, tighten its locknut to
111 N·m (11.3 kgf·m, 81.7 lbf·ft) when you
reinstall it.
A
C
B
4-41