Honda 2004 Odyssey Service Manual page 270

5. Install the oil pump (A).
–1 Apply liquid gasket, P/N 08718-0001 or 08718-
0003, evenly to the block mating surface of the
oil pump and to the inner threads of the bolt
holes.
NOTE: Do not install the parts if 4 minutes or
more have elapsed since applying liquid
gasket. Instead, reapply liquid gasket after
removing old residue.
–2 Grease the lip of the oil seal, and apply oil to
the new O-rings (B).
–3 Install the dowel pins (C), then align the inner
rotor with the crankshaft and install the oil
pump.
–4 Clean the excess grease off the crankshaft, and
check the seal for distortion.
A
B C
D
6. Install the oil screen (D).
7. Clean and dry the oil pan mating surfaces.
8. Apply liquid gasket, part No. 08718-0001 or 08718-
0003, evenly to the oil pan mating surface of the
block and to the inner threads of the bolt holes.
NOTE: Do not install the parts if 4 minutes or more
have elapsed since applying liquid gasket. Instead,
reapply liquid gasket after removing the old
residue.
6 x 1.0 mm
12 N·m (1.2 kgf·m,
8.7 lbf·ft)
B
6 x 1.0 mm
12 N·m (1.2 kgf·m,
8.7 lbf·ft)
9. Install the oil pan on the cylinder block.
Apply liquid gasket
along the broken line.
10. Tighten the bolts in two or three steps. In the final
step, tighten all bolts, in sequence, to 12 N·m
(1.2 kgf·m, 8.7 lbf·ft).
NOTE: After assembly, wait at least 30 minuites
before filling the engine with oil.
11. Install the VTEC solenoid valve and oil filter
assembly (see page 6-10).
12. Install the timing belt drive pulley, then install the
CKP sensor (see step 32 on page 7-27).
13. Install the idler pulley.
14. Install the timing belt (see page 6-23).
15. Remove the chain hoist.
8-11