Engine Block
Oil Pan Installation
1.
Remove any old liquid gasket from the oil pan
mating surfaces, bolts and bolt holes.
2. Clean and dry the oil pan mating surfaces.
3.
Apply liquid gasket, P/N 08718-0001 or 08718-003,
evenly to the oil pan mating surface of the cylinder
block and to the inner threads of the bolt holes.
NOTE: Do not install the parts if 4 minutes or more
have elapsed since applying liquid gasket. Instead,
reapply liquid gasket after removing the
old residue.
Apply liquid gasket
along the broken line.
4. Install the oil pan on the cylinder block.
5. Tighten the bolts in two or three steps. In the final
step, tighten all bolts in sequence to 12 N·m
(1.2 kgf·m, 8.7 lbf·ft).
NOTE: After assembly, wait at least 30 minutes
before filling the engine with oil.
7-28
6. Tighten the two bolts (A) securing the transmission,
then install the torque converter cover (B).
A
10 x 1.25 mm
38 N·m (3.9 kgf·m,
28 lbf·ft)
6 x 1.0 mm
12 N·m (1.2 kgf·m,
8.7 lbf·ft)
B
7. Install the exhaust pipe A (see step 19 on page
5-16).
8.
Refill the engine with oil (see page 8-5).