Honda 2004 Odyssey Service Manual page 467

PGM-FI System
DTC Troubleshooting (cont'd)
12. Check for continuity between ELD 3P connector
terminal No. 2 and body ground.
ELD 3P CONNECTOR
Wire side of female terminals
Is there continuity?
YES Reconnect the ELD 3P connector and PCM
connector A (31P). Go to step 13.
NO Repair open in the wire between the ELD and
G201.
13. Start the engine, and let it idle.
14. While measuring voltage between PCM connector
terminals A26 and E19, turn the headlights on (low).
PCM CONNECTORS
A (31P)
LG1 (BRN/BLK)
E (31P)
Wire side of female terminals
Does the voltage drop?
YES Substitute a known-good PCM and recheck
(see page 11-5). If the symptom/indication goes
away, replace the original PCM.
NO Replace ELD.
11-158 11-158
GND
(BLK)
ELD (GRN/RED)
DTC P1361 '99-00, '02 Models:
1 Circuit Intermittent Interruption
DTC P1362 '99-00, '02 Models:
1 Circuit No Signal
DTC P1366 '99-00, '02 Models:
2 Circuit Intermittent Interruption
DTC P1367 '99-00, '02 Models:
2 Circuit No Signal
1. Reset the PCM (see page 11-4).
2. Start the engine.
Is DT C P1361, P1362, P1366, or P1367
indicated?
YES Go to step 3.
NO Intermittent failure, system is OK at this time.
Check for poor connections or loose terminals at
the TDC1/TDC2 sensor and the PCM.
3. Turn the ignition switch OFF.
4. Disconnect the TDC1/TDC2 sensor 4P connector.
TDC Sensor
TDC Sensor
TDC Sensor
TDC Sensor