Pulley End Crankshaft Seal Installation - In Car; Transmission End Crankshaft Seal Installation - In Car - Honda 2004 Odyssey Service Manual

Pulley End Crankshaft Seal
Installation - In Car
Special Tools Required
Oil seal driver 64 070AD-RCA0100
1. Clean and dry the crankshaft oil seal housing.
2. Apply a light coat of multipurpose grease to the
crankshaft and to the lip of the seal.
3. Using the seal driver, drive in the crankshaft oil seal
until the driver bottoms against the oil pump. When
the seal is in place, clean any excess grease off the
crankshaft, and check that the oil seal lip is not
distorted.
070AD-RCA0100
Transmission End Crankshaft Seal
Installation - In Car
Special Tools Required
• Driver 07749-0010000
• Driver attachment 106 070AD-RCA0200
1. Clean and dry the crankshaft oil seal housing.
2. Apply a light coat of multipurpose grease to the
crankshaft and to the lip of the seal.
3. Using the special tools, drive the crankshaft oil seal
into the engine block end cover until the driver
attachment bottoms against the crankshaft. Align
the hole in the driver attachment with the pin on the
crankshaft.
07749-0010000
070AD-RCA0200
4. Clean any excess grease off the crankshaft, and
check that the oil seal lip is not distorted.
7-29 7-29