Honda 2004 Odyssey Service Manual page 161

Engine Assembly
Engine Installation (cont'd)
16. Install a new set ring on the end of each driveshaft,
then install the driveshafts. Make sure each ring
''clicks'' into place in the differential and
intermediate shaft.
17. Connect the suspension lower arm ball joints (see
page 18-17).
18. Connect the stabilizer links (see page 18-20).
19. Install exhaust pipe A (A); use new gaskets (B) and
new self locking nuts (C).
D
B
C
A
10 x 1.25 mm
54 N·m (5.5 kgf·m,
40 lbf·ft)
Replace.
10 x 1.25 mm
38 N·m (3.9 kgf·m,
28 lbf·ft)
20. Connect the primary heated oxygen sensor
(primary HO2S) connector (D).
5-16
C
10 x 1.25 mm
B
54 N·m (5.5 kgf·m,
40 lbf·ft)
Replace.
C
10 x 1.25 mm
33 N·m (3.4 kgf·m,
25 lbf·ft)
Replace.
21. Install the control lever (A) with the shift cable on
the control shaft. Do not bend the shift cable any
more than is necessary to install the control lever.
6 x 1.0 mm
12 N·m (1.2 kgf·m,
8.7 lbf·ft)
E
A
C
22. Install the lock bolt (B) with a new lock washer (C),
then bend the lock tab of the lock washer.
23. Install the shift cable cover (D), then install the shift
cable holder (E) on the shift cable cover.
B
8 x 1.25 mm
22 N·m (2.2 kgf·m,
16 lbf·ft)
B
6 x 1.0 mm
14 N·m (1.4 kgf·m, 10 lbf·ft)
D