Honda 2004 Odyssey Service Manual page 192

13. Install the auto-tensioner.
NOTE: Make sure the holder (pin for '00-04 models)
stays in place.
1999 model:
6 x 1.0 mm
12 N·m (1.2 kgf·m,
8.7 lbf·ft)
2000-2004 models:
6 x 1.0 mm
12 N·m (1.2 kgf·m, 8.7 lbf·ft)
14. Screw the battery clamp bolt in as shown to hold
the timing belt adjuster in its current position.
Tighten it by hand, do not use a wrench.
15. Apply liquid thread lock to the idle pulley bolt, then
loosley install the idler pulley.
16. Install the timing belt in a counter clockwise
sequence starting with the drive pulley.
–1 Drive pulley (A).
–2 Idler pulley (B).
–3 Front camshaft pulley (C).
–4 Water pump pulley (D).
–5 Rear camshaft pulley (E).
–6 Adjusting pulley (F).
D
E
F
A
C
B
(cont'd)
6-25