Valve, Spring, And Valve Seal Installation - Honda 2004 Odyssey Service Manual

Valve, Spring, and Valve Seal Installation

Special Tools Required
• Stem seal driver 07PAD-0010000
• Valve spring compressor attachment
07757-PJ1010A
• Valve spring compressor,
KD383 with No. 32 jaws, or CF811, commercially
available
• Valve guide seal installer,
KD3372, commercially available
1. Coat the valve stems with new engine oil. Install
the valves in the valve guides.
2. Check that the valves move up and down smoothly.
3. Install the spring seats on the cylinder head.
4. Install the new valve seals (A) using the valve guide
seal installer (B).
NOTE: Exhaust valve seals (C) have a black spring
(D) and intake valve seals (E) have a white spring
(F); they are not interchangeable.
F F F
E E E
A
D D D
C C C
B
07PAD-0010000
NOTE: Use 5.5 mm side.
5. Install the valve spring and valve retainer. Place the
end of the valve spring with closely wound coils
toward the cylinder head.
6. Install the valve spring compressor. Compress the
spring and install the valve keepers.
07757-PJ1010A
7. Lightly tap the end of each valve stem two or three
times with a plastic mallet (A) to ensure proper
seating of the valve and valve keepers. Tap the
valve stem only along its axis so you do not bend
the stem.
A
6-53