Honda 2004 Odyssey Service Manual page 457

PGM-FI System
DTC Troubleshooting (cont'd)
10. Check for continuity between body ground and
PCM connector terminal C8.
PCM CONNECTOR C (31P)
Wire side of female terminals
Is there continuity?
YES Repair short in the wire between the PCM
(C8) and the CKP sensor.
NO Substitute a known-good PCM and recheck
(see page 11-5). If the symptom/indication goes
away, replace the original PCM.
11-148 11-148
CKP
(BLU)
DTC P0335 '01 Model:
No Signal
DTC P0336 '01 Model:
Intermittent Interruption
1. Reset the PCM (see page 11-4).
2. Start the engine.
Is DT C P0335 and/ or P0336 indicated?
YES Go to step 3.
NO Intermittent failure, system is OK at this time.
Check for poor connections or loose terminals at
the CKP sensor and the PCM.
3. Turn the ignition switch OFF.
4. Disconnect the CKP sensor 2P connector.
5. Measure resistance between CKP sensor 2P
connector terminals No. 1 and No. 2.
CKP SENSOR 2P CONNECTOR
CKP
Terminal side of male terminals
Is there 1,850 2,450
YES Go to step 6.
NO Replace the CKP sensor (see page 6-61).
CKP Sensor Circuit
CKP Sensor Circuit
CKP
?