Honda 2004 Odyssey Service Manual page 185

Cylinder Head
Crankshaft Pulley Removal and Installation
Special Tools Required
• Holder handle 07JAB-001020A
• Holder attachment, 50 mm, offset 07MAB-PY3010A
• Socket, 19 mm 07JAA-001020A
or a commercially available 19 mm socket
Removal
1. Remove the right front tire/wheel.
2. Remove the splash shield.
3. Hold the pulley with holder handle (A) and holder
attachment (B).
A
07JAB-001020A
4. Remove the bolt with a heavy duty 19 mm socket
(C) and breaker bar.
6-18
B
07MAB-PY3010A
C
07JAA-001020A
(or commercially available)
Installation
1. Clean the pulleys (A), crankshaft (B), bolt (C) and
washer (D). Lubricate with new engine oil as shown.
: Clean
: Lubricate with new engine oil
A
D
C
2. Install the crankshaft pulley, and tighten the bolt to
245 N·m (25.0 kgf·m, 181 lbf·ft). Do not use an
impact wrench.
–1 Hold the pulley with holder handle (A) and
holder attachment (B).
–2 Tighten the bolt with a torque wrench and
19 mm socket (C).
A
07JAB-001020A
3. Install the splash shield.
4. Install the right front tire/wheel.
A
B
A
B
07MAB-PY3010A
C
07JAA-001020A
(or commercially available)