Honda 2004 Odyssey Service Manual page 459

PGM-FI System
DTC Troubleshooting (cont'd)
DTC P0340 '03-04 Models:
No Signal
DTC P0341 '03-04 Models:
Intermittent Interruption
DTC P0365 '03-04 Models:
No Signal
DTC P0366 '03-04 Models:
Intermittent Interruption
1. Reset the PCM (see page 11-4).
2. Start the engine.
Is DT C P0340, P0341, P0365, or P0366
indicated?
YES Go to step 3.
NO Intermittent failure, system is OK at this time.
Check for poor connections or loose terminals at
the CMP sensor A/B and at the PCM.
3. Turn the ignition switch OFF.
4. Disconnect the CMP sensor A/B 4P connector.
5. Measure resistance between the terminals of the
indicated sensor (see table).
CMP SENSOR A/B 4P CONNECTOR
CMPA
CMPB
Terminal side of male terminals
11-150
CMP Sensor A
CMP Sensor A
CMP Sensor B
CMP Sensor B
CMPA
CMPB
SENSOR DTC SENSOR
TERMINAL
CMP A P0340
P0341
CMP B P0365
P0366
Is there 1,850 2,450
YES Go to step 6.
NO Replace the CMP sensor A/B
(see page 6-60).
6. Check for continuity to body ground on both
terminals of the indicated sensor individually.
CMP SENSOR A/B 4P CONNECTOR
CMPA
CMPB
Terminal side of male terminals
Is there continuity?
YES Replace the CMP sensor A/B
(see page 6-60).
NO Go to step 7.
7. Reconnect the CMP sensor A/B 4P connector.
8. Disconnect PCM connector C (31P).
PCM WIRE
TERMINAL COLOR
1 C20 GRN
2 C21 RED
3 C29 YEL
4 C30 BLK
?
CMPA
CMPB