Honda 2004 Odyssey Service Manual page 456

DTC P0335 '99-00, '02-04 Models:
Sensor Circuit No Signal
DTC P0336 '99-00, '02-04 Models:
Sensor Circuit Intermittent Interruption
1. Reset the PCM (see page 11-4).
2. Start the engine.
Is DT C P0335 and/ or P0336 indicated?
YES Go to step 3.
NO Intermittent failure, system is OK at this time.
Check for poor connections or loose terminals at
the CKP sensor and the PCM.
3. Turn the ignition switch OFF.
4. Disconnect the CKP sensor 2P connector.
5. Measure resistance between CKP sensor 2P
connector terminals No. 1 and No. 2.
CKP SENSOR 2P CONNECTOR
CKP
Terminal side of male terminals
Is there 1,850 2,450
YES Go to step 6.
NO Replace the CKP sensor (see page 6-61).
CKP
CKP
CKP
?
6. Check for continuity between body ground and CKP
sensor 2P connector terminals No. 1 and No. 2
individually.
CKP SENSOR 2P CONNECTOR
CKP
Terminal side of male terminals
Is there continuity?
YES Replace the CKP sensor (see page 6-61).
NO Go to step 7.
7. Reconnect the CKP sensor 2P connector.
8. Disconnect PCM connector C (31P).
9. Measure resistance between PCM connector
terminals C8 and C9.
PCM CONNECTOR C (31P)
Wire side of female terminals
Is there 1,850 2,450
YES Go to step 10.
NO Repair open in the wire between the PCM
(C8, C9) and the CKP sensor.
CKP
CKP
CKP
(WHT)
(BLU)
?
(cont'd)
11-147