Honda 2004 Odyssey Service Manual page 255

Engine Block
Crankshaft and Piston Installation (cont'd)
22. The seal mating surface on the engine block end
cover should be dry. Apply a light coat of multi-
purpose grease to the crankshaft and to the lip of
the seal.
23. Drive the crankshaft oil seal squarely into the
engine block end cover.
07749-0010000
070AD-RCA0200
24. Confirm that the clearance is equal all the way
around with a feeler gauge.
Clearance: 0.2 0.7 mm (0.01 0.03 in.)
0.2 0.7 mm
(0.01 0.03 in.)
7-26
25. Clean and dry the engine block end cover mating
surfaces.
26. Apply liquid gasket, P/N 08718-0001 or 08718-0003,
evenly to the block mating surface of the engine
block end cover and to the inner threads of the bolt
holes. Install the dowel pins (A), new O-ring (B) and
the left side cover (C) on the cylinder block.
NOTE: Do not install the parts if 4 minutes or more
have elapsed since applying the liquid gasket.
Instead, reapply liquid gasket after removing the
old residue.
C
6 x 1.0 mm
12 N·m (1.2 kgf·m, 8.7 lbf·ft)
27. After assembly, wait at least 30 minutes before
filling the engine with oil.
A
B