Show Ipv6 Mroute Source - NETGEAR ProSafe M7100-24X User Manual

Term Definition
Source IP
The IP address of the multicast data source.
Group IP
The IP address of the destination of the multicast packet.
Protocol
The multicast routing protocol by which this entry was created.
Incoming
The interface on which the packet for this group arrives.
Interface
Outgoing
The list of outgoing interfaces on which this packet is forwarded.
Interface List

show ipv6 mroute source

This command displays the multicast configuration settings specific to IPv6 such as flags,
timer settings, incoming and outgoing interfaces, RPF neighboring routers, and expiration
times of all the entries in the multicast mroute table containing the given source IP address or
source IP address and group IP address pair.
Format
show ipv6 mroute source <source-address> {detail | summary}
Modes
• Privileged EXEC
• User EXEC
If you use the detail parameter, the command displays the following column headings in
the output table:
Term Definition
Source IP
The IP address of the multicast data source.
Group IP
The IP address of the destination of the multicast packet.
Expiry Time
The time of expiry of this entry in seconds.
Up Time
The time elapsed since the entry was created in seconds.
RPF Neighbor
The IP address of the RPF neighbor.
Flags
The flags associated with this entry.
If you use the summary parameter, the command displays the following column headings in
the output table:
Term Definition
Source IP
The IP address of the multicast data source.
Group IP
The IP address of the destination of the multicast packet.
Protocol
The multicast routing protocol by which this entry was created.
ProSafe Managed Switch
IPv6 Multicast Commands
419