Check Imaging Unit Error - Xerox Phaser 6128MFP Service Manual

Check Imaging Unit Error

Phaser 6128MFP Service Manual
The Imaging Unit sealing tapes are present or the Imaging Unit is improperly
seated.
Applicable Error
• Check Imaging Unit
Initial Actions
• Check that the correct Imaging Unit is installed for this model.
• Remove, inspect, and reseat the Imaging Unit.
• Cycle system power.
• If the problem persists, follow the procedure below.
Troubleshooting Reference Table
Applicable Parts
Imaging Unit PL4.1.21
MCU Board, PL10.7.7
Troubleshooting Procedure Table
Step Actions and Questions
1 Remove the Imaging Unit and
inspect for damage, debris, or
sealing tapes.
Does the error persist?
2 Replace the Imaging Unit
(page 8-8).
NOTE
Does the error persist?
Wiring and Plug/Jack Map References
Remove the 8 sealing tapes from
the new Imaging Unit before
installation.
Error Messages and Codes
"Map 1 - MCU Board" on page 10-6
"Xerographics" on page 10-18
Yes No
Go to step 2. Complete.
Replace the Complete.
MCU Board
(page 8-57)..
3-71