14.Resource output lines are enabled by setting the corresponding PFR and/or EPFR bit in the port. Details
see section
Port Function Register Setup on page
additionally by setting the SOE bit in the LIN-USART control.
15.Resource bidirectional signals (e.g. SCK of the LIN-USART) are enabled by setting the corresponding
PFR and/or EPFR bit in the port. The signal direction is controlled by the setup of the resource, e.g. via the
output enable bits. Details see section
458. LIN-USART outputs (SOT) must be enabled
Port Function Register Setup on page
Chapter 30 I/O Ports
3.Port Register Settings
458.
455