Setting - Fujitsu MB91460 SERIES FR60 User Manual

6. Setting

Table 6-1 Settings Needed to Start the PPG
Setting
Period and duty value settings
Enable PPG operation.
Operation mode selection (PWM/one-shot)
Enable restart.
Count clock selection
PPG output mask selection
Trigger selection
Software
Internal trigger
External trigger
Output polarity specification
PPG pin output setting
Trigger generation (software trigger)
(Reload timer)
(GCN2.EN bit)
* For refer to the section indicated by the number.
Table 6-2 Settings Needed to Stop the PPG
Setting
PPG stop bit setting
*For the setting procedure, refer to the section indicated by the number.
Table 6-3 Settings Needed to Clamp the Output Level
Setting
Output polarity specification
PPG output mask selection
Period value = Duty value setting
*For the setting procedure, refer to the section indicated by the number.
Table 6-4 Settings Needed to Implement PPG Interrupts
Setting
PPG interrupt vector, PPG interrupt level setting
Setting Registers
PPG cycle settings (PCSR00-PCSR15)
PPG duty settings (PDUT00-PDUT15)
PPG control status (PCN00-PCN15)
General Control 1 (GCN10, GCN11, GCN12,
GCN13)
Port functions (PFR16, PFR17)
PPG Control Status (PCN00-PCN15)
See "Chapter 38 Reload Timer (Page
No.775)".
General Control 2 (GCN20, GCN21, GCN22,
GCN23)
Setting Registers
PPG control status (PCN00-PCN15)
Setting Registers
PPG control status (PCN00-PCN15)
PPG duty settings (PDUT00-PDUT15)
Setting Registers
See "Chapter 24 Interrupt Control (Page
No.311)".
Chapter 39 Programmable Pulse Generator
Setting
Procedure
7.1
7.2
7.3
7.4
7.5
7.6
7.7
7.8
7.9
7.10
Setting
Procedure
7.11
Setting
Procedure
7.8
7.6
7.6
Setting
Procedure
7.12
6.Setting
*
*
*
*
811