Fujitsu MB91460 SERIES FR60 User Manual page 239

Table 2-1 describes the function of each bit of the Clock Supervisor Control Register (CSVCR).
Table 2-1 Functional Description of each bit of the Clock Supervisor Control Register
Bit Name
7 SCKS
(Sub-clock
select)
6 MM
(Main
missing)
5 SM
(Sub-clock
missing)
4 RCE
(RC-oscillator
enable)
3 MSVE
(Main
supervisor
enable)
2 SSVE
(Sub-clock
supervisor
enable)
1 SRST
(Sub-clock
mode reset)
0 OUTE
(Output
enable)
Function
This bit is to select between 32k external oscillation and internal RC
oscillation as subclock. If this bit is 0 then the external 32k oscillation is
used as subclock, if it's 1 then the internal RC oscillation is used as
subclock.This bit is cleared to '0' by Power-On reset or external reset.
Other types of reset will not affect this bit.
If this bit is 1, the main clock supervisor has detected that the main
clock oscillation clock coming from X0, X1 is missing, e.g. by a broken
crystal. If this bit is 0, a missing main clock has not been detected.
Writing this bit has no effect. This bit is cleared to '0' by Power-On reset
or external reset. Other types of reset will not affect this bit.
If this bit is 1, the sub-clock supervisor has detected that the sub
oscillation clock coming from X0A, X1A is missing, e.g. by a broken
crystal. If this bit is 0, a missing sub-clock has not been detected.
Writing this bit has no effect. This bit is cleared to '0' by Power-On reset
or external reset. Other types of reset will not affect this bit.
Setting this bit to 1 enables the RC-oscillator. Do not disable the RC-
oscillator by setting this bit to 0 while the main or sub-clock supervisors
are still enabled. First the supervisors must be disabled, then it must be
checked that MM and SM are '0', then RCE can be set to '0'. If either
MM or SM bits are '1', RCE must not be set to '0'. This bit is set to '1' by
Power-On reset or external reset. Other types of reset will not affect this
bit.
Setting this bit to 1 enables the main clock supervisor. When this bit is
clock set to 1, the RC-oscillator must have been enabled by the RCE bit for at
least 100µs. This bit is set to '1' by Power-On reset only. Other types of
reset will not affect this bit.
Setting this bit to 1 enables the sub-clock supervisor. When this bit is
set to 1, the RC-oscillator must have been enabled by the RCE bit for at
least 100µs. This bit is set to '1' by Power-On reset only. Other types of
reset will not affect this bit.
If this bit is set to 1, a reset is performed upon transition from main/PLL
clock mode to sub-clock mode if the sub-clock is already missing. If this
bit is set to 0, no reset is performed in this case. This bit is cleared to '0'
by Power-On reset or external reset. Other types of reset will not affect
this bit.
This bit can be used as an output enable to output the signals MM (bit 3
of CSVCR) and SM (bit 4 of CSVCR) to port pins. If this bit is set to '1',
the ports are enabled for MM and SM output. This bit is cleared to '0' by
Power-On reset or external reset. Other types of reset will not affect this
bit.
Chapter 16 Clock Supervisor
2.Clock Supervisor Register
223