Fujitsu MB91460 SERIES FR60 User Manual page 249

■ Sub-clock modes
The main clock supervisor is automatically disabled in sub-clock modes. The enable bit MSVE remains
unchanged. At transition from sub-clock mode to main clock mode the main clock supervisor is enabled after the
'oscillation stabilisation wait time' with the rising edge of signal OSC_STAB or in case the main clock is missing
before the completion of the 'oscillation stabilisation wait time', after the 'main clock timeout' (TO_MCLK) from
the timeout counter. The timeout counter is clocked with RC-oscillation clock.
■ Changing the behaviour upon transition to sub-clock mode if the sub-clock has already
stopped in main clock mode
If the sub-clock has stopped in main clock mode and this was detected by the sub-clock supervisor, the
behaviour upon transition to sub-clock mode depends on the state of the SRST bit.
• If SRST is set to '0' (initial value), reset is not asserted at the transition to sub-clock mode. The transition is
performed using the RC-oscillation clock as sub-clock. In this case it is recommended to check the SM bit
before the transition to sub-clock mode to get the information if sub-clock or RC-oscillation clock is used.
• If SRST is set to '1', reset is asserted at the transition to sub-clock mode.
The following timing diagrams
Figure 4-8 Timing Diagram: Sub-clock missing in main clock mode, SRST=0
PONR
MCLK
SCLK
RC_CLK
OSC_STAB
TO_MCLK
TO_SCLK
MSVE
MSEN
SSVE
SSEN
MCLK_STBY
SCLK_STBY
SRST
EXT_RST
EXT_RST_OUT
MCLK_OUT
SCLK_OUT
MCLK_MISSING
SCLK_MISSING
Clock Mode
(Figure 4-8, Figure 4-9, Figure 4-10) illustrate this behaviour.
Main
Chapter 16 Clock Supervisor
4.Operation Modes
Sub
233