Setting; Caution - Fujitsu MB91460 SERIES FR60 User Manual

6. Setting

Table Setting required for the delayed interrupt generation/clear
Table 6-1 Setting required for the delay interrupt generation/clear
Vector for delay interrupt
Delayed interrupt setting.
Generating interrupt request/Releasing interrupt request
*: Refer to the number for the setting method.
7. Q & A
7.1 What are interrupt-associated registers?
Setting for the delay interrupt vector and interrupt level
The relationship between the delay interrupt level and the delay interrupt vector is shown in the following table.
Refer to "Chapter 24 Interrupt Control (Page
vector.
Interrupt vector (default)
#63
Address: 0FFF00h
The interrupt request bit (DICR.DLYI) cannot automatically be released, and it should be released by the
software before returning from an interrupt service. ("0" is written for DLYI bit)
Remark: For REALOS compatibility reasons, ICR23 and ICR47 can be exchanged by setting the REALOS
compatibility bit (addr 0x0C03 : IOS[0]) if necessary.
7.2 How is the interrupt request generated/cleared?
The delayed interrupt request bit (DICR.DLYI) performs this function.
Clearing an interrupt request
Generating an interrupt request
The delayed interrupt does not have an interrupt request enable bit.

8. Caution

• The delay interrupt request bit is the same as general interrupt request flags. It should be used to clear
delayed interrupt request bit in an interrupt routine in addition to switching tasks.
• The delayed interrupt function can use real time OS (REALOS). As a result, the delayed interrupt function is
prohibited in a piece of user software when using real time OS.
Setting Setting register
Refer to "Chapter 24 Interrupt Con-
trol (Page No.311)"
Delayed interrupt control register
(DICR)
No.311)" for more information on the interrupt level and interrupt
Interrupt level setting bit (ICR[4:0])
Interrupt level register (ICR23)
Address: 00457h
Interrupt request enable bit (DLYI)
Sets the value to "0"
Sets the value to "1"
Chapter 27 Delayed Interrupt
6.Setting
Setting method*
Refer to 7.1
Refer to 7.2
385