Fujitsu MB91460 SERIES FR60 User Manual page 218

Chapter 13 Clock Control
7.Q & A
7. Q & A
7.1 How do I enable or disable clock operation?
• There is no operation enable bit for the main clock. Main clock operation is always enabled.
(Halting the oscillation in subclock mode or stop mode is handled separately.)
• Main PLL operation is enabled by the main PLL operation enable bit (CLKR.PLL1EN).
Operation
To halt the main PLL
To enable operation of the main PLL
Initially, the PLL is halted and therefore PLL operation must be enabled and the PLL started after setting the PLL
multiplier ratio.
• The subclock on the MB91460 does not halt and therefore no corresponding operation enable bit is
provided.
Instead, the subclock selection enable bit (CLKR.SCKEN) is used.
Operation
Subclock selection prohibited
To enable selection of the subclock
7.2 How do I select the main PLL multiplier ratio?
• The PLL multiplier can be set by using the PLL interface registers PLLDIVM and PLLDIVN (see chapter
"PLL Interface" on P. 207
7.3 How do I select the operating clock source?
Use the clock source selection bits (CLKR.CLKS[1:0]) to select main clock divided by 2, main PLL, or the
subclock as the operating clock source.
Operating clock source
To change from the initial value to the main clock divided by 2 Set initial values "00" or "01".
To change from the initial value to the main PLL
To change from the initial value to the subclock
To change from the subclock to the main clock divided by 2
To change from the subclock to main PLL
To change from main PLL to the main clock divided by 2
To change from main PLL to the subclock
202
).
Main PLL operation enable bit (PLL1EN)
Set to "0".
Set to "1".
Subclock selection enable bit (SCKEN)
Set to "0".
Set to "1".
Clock source selection bits (CLKS[1:0])
Change from the initial values "00" to "10".
First change from the initial values "00" to "01", and
then to "11".
Change from "11" to "01".
First change from "11" to "01", next set
"00", and then set "10".
Change from "10" to "00".
First change from "10" to "00", next set
"01", and then set "11".