Fujitsu MB91460 SERIES FR60 User Manual page 610

Chapter 31 External Bus
10.DMA Access Operation
10.2 DMA Fly-By Transfer (Memory -> I/O)
This section explains DMA fly-by transfer (memory -> I/O).
■ DMA Fly-By Transfer (Memory -> I/O)
Figure 10-2 "Timing chart for DMA Fly-By Transfer (Memory -> I/O)" shows the operation timing chart for (TYP3-
0=0000 , AWR=0008
B H
Figure 10-2 "Timing chart for DMA Fly-By Transfer (Memory -> I/O)" shows a case in which a wait is not set on
the memory side.
Figure 10-2 Timing chart for DMA Fly-By Transfer (Memory -> I/O)
FR30
compatible
mode
Basic
mode
• Setting 1 for the HLD bit of the IOWR0-3 registers extends the I/O read cycle by one cycle.
• Setting bits WR1-0 bits of the IOWR0-3 registers enables 0-3 write recovery cycles to be inserted.
• If the write recovery cycle is set to 1 or more, a write recovery cycle is always inserted after write access.
• Setting bits IW3-0 of the IOWR0-3 registers enables 0-15 wait cycles to be inserted.
• If wait is also set on the memory side (AWR15-12 is not 0), the larger value is used as the wait cycle after
comparison with the I/O wait (IW3-0 bits).
594
, IOWR=41 ).
H
Basic cycle
MCLK
A[31:0]
AS
CSn
RD
D[31:0]
DACKn
DEOPn
DACKn
DEOPn
IORD
DREQn
I/O wait I/O hold
cycle wait
memory address
Sense timing in
demand mode