Setting - Fujitsu MB91460 SERIES FR60 User Manual

5. Setting

Table 5-1 Settings needed to use A/D - Single-Shot Conversion Mode
Setting
Mode selection (Single-shot conversion)
Bit length selection
Channel selection
Conversion time setting
To program the AN pin as an input
A/D activation trigger selection
A/D activation trigger generation
Software trigger
-> Software trigger bit setting
Reload timer
-> Reload timer rising output
External trigger
-> Inputs a trigger to the ADTG(0, 1) pin.
Conversion end flag check
Conversion value read
*: For the setting procedure, refer to the section indicated by the number.
Table 5-2 Settings needed to use A/D - Scan Conversion Mode
Setting
Mode selection (Scan conversion)
Bit length selection
Starting channel selection
Conversion time setting
Program the AN pin as an input.
A/D activation trigger selection
A/D activation trigger generation
Software trigger
-> Software trigger bit setting
Reload timer
-> Reload timer falling output
External trigger
-> Inputs a trigger to the ATGX pin.
Conversion end flag check
Conversion value read
*: For the setting procedure, refer to the section indicated by the number.
Setting Registers
A/D control (ADCS)
Conversion time setting (ADCT)
Port Function (PFR26-PFR29) and Extra Port
Function (EPFR26-EPFR27)
A/D control (ADCS)
See "Chapter 38 Reload Timer (Page
No.775)".
External input
A/D control (ADCS)
Data buffers (ADCR)
Setting Registers
A/D control (ADCS)
Conversion time setting (ADCT)
Port Function (PFR26-PFR29) and Extra Port
Function (EPFR26-EPFR27)
A/D control (ADCS)
See "Chapter 38 Reload Timer (Page
No.775)".
External input
A/D control (ADCS)
Data buffers (ADCR)
Chapter 44 A/D Converter
5.Setting
Setting
Procedure*
See 7.1
See 7.2
See 7.3
See 7.4
See 7.5
See 7.6
See 7.7
See 7.8
See 7.9
Setting
Procedure*
See 7.1
See 7.2
See 7.3
See 7.4
See 7.5
See 7.6
See 7.7
See 7.8
See 7.9
899