Table of Contents
Advertisement
recommended that the Sub-Second register is updated while the ST bit is "0".
However, if this update is done immediately after an RTC second interrupt there should be enough time to
securely modify the registers until the next reload operation (next second interrupt) even if ST is not set to
"0" and the module is in operation.
When updating the registers by using the ST bit the following must be taken into account:
The new value is written into the registers with the rising edge of the RUN bit. This RUN bit is clocked by the
RTC clock (32 kHz, 100kHz or 4 MHz depending on device and mode). To make sure that the update is
done properly, write the new values into the registers, set ST to 0, wait for the RUN bit to go low and then
start the circuit again by setting ST to 1. RUN will go low at the second rising edge of the RTC clock after ST
has been set to 0. It will rise again at the half second rising edge of RTC clock after ST has been set to 1. If
this operation is to be done several times directly after each other, wait for RUN to go to high before setting
ST to low again.
• WTCER: Address 04A1
7
6
–
–
–
–
–
–
RX/WX
RX/WX
(For attributes, refer to
• bit7-2
Undefined
:
Writing does not affect the operation. The read value is indeterminate.
• bit1: Enable interrupt requests at half-second (500ms) intervals
INTE4
0
No interrupt requests
1
Generate interrupt requests at half-second (500 ms) intervals.
When the hour counter overflows, this flag is set to "1".
• bit0: half-second (500ms) interrupt request flag
INT4
0
No interrupt requests
Generate interrupt requests at half-second (500 ms)
1
intervals.
(Access: Byte)
H
5
4
–
–
–
–
–
–
RX/WX
RX/WX
RX/WX
"Meaning of Bit Attribute Symbols (Page
Read
3
2
1
–
–
INTE4
–
–
0
–
–
0
RX/WX
R/W
No.10)".)
Operation
Status
Clear the flag.
Writing does not affect the operation.
Chapter 49 Real-Time Clock
0
bit
INT4
Initial
0
value
0
When reset
R(R1),W
Attribute
Write
4.Registers
953
Advertisement
Table of Contents
