Fujitsu MB91460 SERIES FR60 User Manual page 599

MCLK
A
D
SRAS,SCAS,
SWE
Set the W07 and W06 bits in the area wait register (AWR) to the read - to - write idle cycle according to the
SDRAM/FCRAM standards.
■ Single Read Operation Timing
Figure 9-3 shows the operation timings assuming that page misses, CAS latency 3, and no auto - precharge are
set.
MCLK
A
D
SRAS,SCAS,
SWE
• When a page miss occurs, a read operation is performed after the PRE charge and ACTV commands are
issued.
• Set the W01 and W00 bits in the area wait register (AWR) to the RAS precharge cycle (tRP) according to the
SDRAM/FCRAM standards.
• Set the W14 to W12 bits in the area wait register (AWR) to the RAS - to - CAS delay (tRCD) according to the
SDRAM/FCRAM standards.
■ Single Read/Write Operation Timing
Figure 9-4 shows the operation timings assuming that CAS latency 1, TYP = 1001
Figure 9-2 Single Read/Write Timing Chart
#1
#1
READ
Read
Cas Latency
Idle cycle
Read cycle
Figure 9-3 Single Read Timing Chart
BA Row
PRE ACT
RAS precharge cycle
(tRP)
#1
#1
WRIT
Write
Write cycle
#1
READ
RAS → CAS delay
Cas Latency
(tRCD)
Chapter 31 External Bus
9.SDRAM/FCRAM Interface Operation
#1
, and auto - precharge are set.
B
583