Fujitsu MB91460 SERIES FR60 User Manual page 375

Table 3-3 Specifiable transfer addresses (demand transfer 2-cycle transfer)
Transfer source address
External area
External area
External area
Built-in IO
Built-in RAM
Note:
For a demand transfer, be sure to set an external area address for the transfer source or transfer destination or
both. Since DMA transfer is adjusted to the external bus timing in demand transfer mode, access to external
areas is always needed.
● Demand transfer fly-by transfer
A demand transfer fly-by transfer has the same features as a 2-cycle transfer except that the transfer area can
only be external areas, and the transfer unit is read (memory --> I/O) or write (I/O --> memory) only.
Table 3.2-3 Specifiable transfer addresses (demand transfer fly-by transfer)
Transfer source addressing
Specification not required (invalid)
● Step/block transfer 2-cycle transfer
For a step/block transfer (Transfer for each transfer request is performed as many times as the specified block
count), all 32-bit areas can be specified as the transfer source/transfer destination address.
Table 3-4 Specifiable transfer addresses (step/block transfer 2-cycle transfer)
Transfer source addressing
All 32-bit areas specifiable
[Step transfer]
If 1 is set as the block size, a step transfer sequence is generated.
The following are some features of a step transfer:
• If a transfer request is received, the transfer request is cleared after one transfer operation and then the
transfer is stopped (The DMA transfer request to the bus controller is canceled).
• Another request occurring during transfer is ignored.
Direction Transfer destination addressing
Direction Transfer destination addressing
=> External area
Direction Transfer destination addressing
=> All 32-bit areas specifiable
Chapter 26 DMA Controller
3.DMA Controller (DMAC) Operation
External area
Built-in IO
Built-in RAM
External area
External area
359