Setting Up The Device; Connecting The Machine To The Mains - Fujitsu ESPRIMO P7XX Operating Manual

Getting started

Setting up the device

Device Ergonomic Workstation
When installing your device, please read the recommendations and safety
notes in the "Safety/regulations" manual.
We recommend that you place your device on a surface which is not slippery. In
view of the many different finishes and varnishes used on furniture, it is possible
that the rubber feet will mark the surface they stand on.
Depending on the location of your device, bothersome vibrations and noises may
occur. To prevent this, a distance of at least 10 mm / 0.39 in should be maintained
from other devices on casing sides without ventilation surfaces.
In order to avoid overheating, do not cover the ventilation areas
of the monitor or the device.
A minimum distance of 200 mm / 7.87 in from the device must be
observed for ventilation areas.
Do not stack several devices on top of each other.
Do not expose the device to extreme ambient conditions (see
section "Ambient conditions"). Protect the device against dust, humidity and heat.

Connecting the machine to the mains

Mainsadapter,
► Connect the mains cable to the machine (1).
► Plug the mains plug into a three-pin socket (2).
14
1
"Technical data", Page
2
58,
Fujitsu