Avaya Communication Manager Contact Center Manual page 362

Guide to acd contact centers
Table of Contents

Advertisement

Implementing the Time of Day Clock Synchronization feature
Example derivation of synchronization task run time on the Avaya Site
Administration client PC (continued)
Local Time / Normalized Standard
Time for synchronization at switch
Switch 4 (London)
Local time:
Adjusted Standard Time:
1. Synchronization run times should occur during low traffic periods at the switch. In this example, the
simplifying assumption is made that a single low-traffic time (at the switch) is common to all switch
locations. This assumption may not be true for all contact center operations.
2. Listed offset values are those that were derived in
Synchronization scheduling
3. If the PC client clock is currently set to DST rules, add 1 hour to the synchronization start time that
you specify in the Avaya Site Administration Schedule dialog. If the PC client and switch locations
do not use the same DST rules, see
page 362.
4. Run times entered in the Schedule dialog of the Avaya Site Administration Time Synchronization
feature must be specified in 12-hour, AM/PM time format.
Special considerations for synchronization start times
If the PC client and switch locations do not use the same DST rules, actual synchronization
run times will vary by an hour over the course of the year. Depending on how DST rules
between the switch and client PC vary, the actual synchronization run time at the switch
will occur either one hour earlier or later than the time specified in Avaya Site
Administration. The following basic rules apply:
Note:
Note:
When DST is in effect at the switch, but not at the PC client, the actual synchronization
run time at the switch will occur 1 hour later than the run time that is specified on the
client PC.
362 Communication Manager Guide to ACD Call Centers
1
location
03:07 BST
03:07 BST
on page 359.
The exceptions described below relate to synchronization start times, only.
As long as offsets are calculated correctly, as described in
location offset values
have no effect on the accuracy of the synchronization.
Client / Switch
Offset
Example offset calculations used in Time
Special considerations for synchronization start times
on page 359, the start time exceptions listed below
Synchronization
2
run time set on
client PC
+5
Determining
3,4
8:07 AM
on

Advertisement

Table of Contents
loading

Table of Contents