Installing The Pbx Driver, Chap And Pbx Task Server; Installing The Pbx Driver - Avaya Customer Interaction Express 1.0 User Manual

Installing the PBX driver, CHAP and PBX task server

You must install the PBX driver, CHAP and PBX task server components. For information on how to do
so, see the following instructions:
When you set up the individual components, you will be prompted to choose a complete or customer
installation. This manual assumes you always select a complete installation!

Installing the PBX driver

To install the PBX driver, follow these steps.
1. The guided installation is open. Start Avaya ACM PBXDriver. The Welcome dialog opens.
2. Click Next. The Setup Type dialog opens.
3. Use the default setting Complete.
4. Click Next. The General Settings dialog opens. Enter the following settings.
Settings
Host name of the CORBA
naming service
Port
Host name of Trace
system server
Port
5. Click Next. The General Settings dialog opens. Enter the following settings.
Settings
Corbaname
Session-ID
Telephony Server List
New Server
6. Click Next. The CSTA Server selection dialog opens.
136 User Manual CIE 1.0 System Administration
Explanation
Specifies the host name or TCP/IP address of the OmniOrb server.
Specifies the port for accessing the OmniOrb server. 2809 is the
default setting.
Specifies the host name of the TTrace server.
Specifies the port for accessing the TTrace server. 10300 is the
default setting.
Explanation
This setting is entered automatically. You cannot edit the name.
Specifies the session ID of the PBX driver. This session ID is used
to specify the assignment between the PBX driver and PBX task
server. A PBX driver must always be assigned to a PBX task server.
This assignment is always one-to-one. The session ID is usually 0,
which is the default setting. Enter the session ID of the PBX task
server in the configuration (User Interface - Configuration module).
Shows the known TCP/IP numbers of the AES server.
Specifies the TCP/IP number or host name (name resolution must
be specified) of the AES server. To add a server, enter it in the list
and click add to list.