Front and Rear Suspension
Wheel Alignment (cont'dl
Front Caster Inspection/Adiustment
Use commerciallv available computerized four wheel
alignment equipment lo measure wheel alignment
{caster, camber, toe, and turning angle) Followthe
eouiDment manufacturer's instructions.
1. Check the caster angle. lf adjustmentis required,
go to step 2.
Front caster angle: 6'00'+ 15'
2 . H o l d t h e f l a n g e b o l t ( A ) o n t h e r e a r o f t h e l o w e r a r m ,
a n d l o o s e n t h e s e l f - l o c k i n g n u t ( B ) .
B '12
\1.25 mm
Turn the adjusting cam collar (C) until the caster is
correct.
After adjusting, tighten the self-locking nut while
holding the flange bolt.
18-6
Front Camber Inspection/Adiustment
Use commercially available computerized four wheel
alignment equipment to measure wheel alignment
(caster. camber, toe, and turning angle) Followthe
equipment manuJacturer's instructions.
1. Check the camber angle. lf adjustment is req ulred,
go to step 2.
Front camber angle: -0'30't
10'
2 . H o l d t h e a d j u s t i n g b o l t ( A ) o n t h e f r o n t o f t h e l o w e r
arm, and loosen the self-locking nut (B).
B
12 x '1.25 mm
78 N.m {8.0 kgf m.58 lbf ft)
, -- -11'',
Turn the adjusting bolt untilthe camber is correct.
After adjusting, tighten the self-locking nut while
holding the adjusting bolt.