Honda S2000 Service Manual page 134

Gylinder Head
Cam Chain Installation (cont'd)
4. Remove old liquid gasket from the chain case
mating surfaces, bolts and bolt holes,
5. Clean and dry the chain case mating surfaces.
6. Apply liquid gasket, part No. 08718-0009, evenly to
the cylinder block mating surface of the chain case
and to the inner threads of the bolt holes.
NOTE: Do not install the parts if 5 minutes or more
have elapsed since applying liquid gasket. Instead,
reapply liquid gasket after removing old residue.
Apply liquid gasket
along the broken line.
I n s t a l l t h e d o w e l p i n s ( A ) a n d c h a i n c a s e ( B ) u s i n g a
new O-ring (C).
7 .
B
6 x 1 . 0 m m
1 2 N . m
(1,2 kgf.m,8.7 lbf.ft)
1 0 x 1 . 2 5 m m
,14 N.m
6-20
9 .
1 0 .
Remove old liquid gasket from the oil pan mating
surfaces, bolts and bolt holes.
Clean and dry the oil pan mating surfaces.
Apply liquid gasket, part No. 08718 0009, evenly to
the cylinder block mating surface of the oil pan and
t o t h e i n n e r t h r e a d s o f t h e b o l t h o l e s . I n s t a l l t h e o i l
p a n .
NOTE: Do not install the parts if 5 minutes or more
have elapsed since applying liquid gasket. Instead,
reapply liqu id gasket after removing old residue.
Apply liquid gasket
a l o n g t h e b r o k e n l i n e .
Tighten the bolts in two orthree steps. In the final
step, tighten all bolts, in sequence, to 12 N m
( 1 . 2 k g f m , 8 . 7 l b f . f t ) .
1 ' t .