Install the glass and regulator in the reverse order of removal. and note these items:
. Hold the adjusting bolts with a hex wrench when installing the locknuts.
. Before installing the regulator, Apply multipurpose grease to allthe sliding surfaces ofthe regulator.
. Make sure the connector is plugged in properly.
. Roll the glass up and down to see if it moves freely without binding.
' M a k e s u r e t h a t t h e r e i s n o c l e a r a n c e b e t w e e n t h e g l a s s a n d r o o f w e a t h e r s t r i p s w h e n t h e g l a s s i s c l o s e d .
. Adjust the position of the glass as necessary (see page 20-1 1).
. Check for water leaks {see step 17 on page 20-14),
. Test-drive and check for wind noise and rattles.
' When reinstalling the door panel, make sure the plastic cover is installed properly and sealed around its