Steering Wheel Installation - Honda S2000 Service Manual

Steering
Steering Wheel Installation
1. Before installing the steering wheel, make sure the
front wheels are aligned straight ahead, then center
the cable reel (A). Do this by first rotating the cable
reel clockwise unlil it stoos. Then rotate it
counterclockwise about two and half turns. The
a r r o w m a r k ( B ) o n t h e c a b l e r e e l l a b e l p o i n t s h o u l d
point straight up.
Position the two tabs (A) of the turn signal
c a n c e l l i n g s l e e v e ( B ) a s s h o w n , a n d i n s t a l l t h e
steering wheel on to the steering column shaft,
making sure the steering wheel hub (C) engages
the pins (D) of the cable reel and tabs of the
canceling sleeve. Do not tap on the steering wheel
or steering column shaft when installing the
steering wheel.
2 .
17-8
3. lnstallthe steering wheet bolt and tighten it.
39 N m {4.0 kgf m,29lbf.ft}
7 .
Connect the horn switch connector and cruise
control switch connector.
Install the driver's airbag, and confirm that the
system is operating properly (see page 23-66).
Reconnect the battery.
Check the horn, cruise control sevresume switch,
and turn signal cancelling for proper operation.
Enter the anti-theft code for the radio, then enter
the customer's radio station presets.
For'01-03 models; reset the clock.