Roof Position Adjustment - Honda S2000 Service Manual

Roof Position Adjustment
NOTE: Have an assistant help you adjust the roof position.
1. Remove the B-pillar trim from both sides (see page 20-55), and make sure both lock handles (A) androofside
6 x 1 . 0 m m
9.8 N.m
(1.0 kgf m,7.2lbt ftl
K
8 x 1.25 mm
22 N.m
(2.2 kgf.m, 16lbf.ft)
Measuing Point IA]
Measuring Point [B]
ROOF MOLDING
LOCK
8 a l m m
(0.31 0.04 in.)
UNLOCK
1 4 1 l m m
{0.55 + 0.04 in.}
t
.r)
6 . 6 a 1 m m
(0.26 A 0.04 in.)
2. Set the roof (C) onto the body (D):
. l\/lake sure the lock pins {E) of both roof side locks are securely inserted into the body side catches (F).
. lMake sure the rear window defogger harnesses are not pinched.
Adjust the roof alignment:
- 1 C h e c k t h a t t h e r e i s n o c l e a r a n c e b e t w e e n t h e s t r i k e r ( G ) a n d t h e b o s s ( H ) o f t h e l o c k h a n d l e a t t h e m e a s u r i n g
points (A), and check that the clea ra nce is wilh in specification at the measu ring points IBJ onthebottomof
both rear pillars.
-2 To fit the boss into the striker, and to adjust the vertical clearance to the specification, loosen the roof side
lock mounting bolts (l), then move the roof up or down, as well as. forward and rearward.
- 3 T o a d j u s t t h e h o r i z o n t a l c l e a r a n c e b e t w e e n b o t h s i d e e d g e s o f t h e r o o f a n d t h e r e a r t r a y o p e n i n g m o l d i n g ( J )
to the specification, loosen the holder plate mounting bolts (K), then move the roof to the right or left.
-4 Fasten both roof side locks.
-5 Lock the roof securely with both lock handles and roof side locks.
-6 Recheck the roof alignment.
(cont'd)
184 mm
17.24 in.l
:/'
20-65