Honda S2000 Service Manual page 566

'11.
Remove and discard the cotter pin (A)Jrom the
12 mm nut (B). then remove the nut.
B
12 x 1.25 mm
07MAC-S100200
S e p a r a t e t h e t l e - r o d b a l l j o i n t a n d k n u c k l e u s i n g t h e
s p e c i a l t o o l ( s e e p a g e 1 8 - 1 0 ) .
Remove the seven clips {A) and the two flange
b o h s ( B ) , t h e n r e m o v e t h e s p l a s h s h i e l d ( C ) .
'13.
6 x l . 0 m m
14. Remove the stabilizer bar holder brackets {A) from
the frame, and lower the stabilizer bar (B).
6 6
Disconnect the ground cable (A) and motor 2P
connector (B). Loosen the harness band (C), and
release the wire harness (D) from the gearbox.
After disconnecting the connector, put a piece of
tape over the steering gearbox connector to protect
it from dust, dirt, and foreign materials.
(cont'd)
17-47