Dtg 4-3: Short To Another Wire - Honda S2000 Service Manual

sRs
DTC Troubleshooting (cont'd)
DTG 4-3: Short to Another Wire or Decreased
Resistance in Passenger's Seat Belt
Tensioner
SpecialTools Required
. SRS inflator simulator 07SAZ-T84011A
. SRS simulator lead C 07TM-S250114
1. Erase the DTC memory (see page 23-19).
2. Turn the ignition switch ON (ll), and check that the
SRS indicator comes on for about 6 seconds and
then goes off.
Does the SFIS indicator stay on?
YES Go to step 3.
NO Intermittent failure, system is OK at this time.
Go to Troubleshooting Intermittent Failures {see
p a g e 2 3 - 1 9 ) .
3. Turn the ignition switch OFF, then disconnect the
battery negative cable, and wait for 3 minutes.
4. Disconnect the passenger's seat belt tensioner 2P
connector from the SRS main harness (A).
AZ-S25011A
\or"or-r"oorro
Connect the SRS inflator simulator (2 0 connector)
a n d t h e s i m u l a t o r l e a d t o t h e S R S m a i n h a r n e s s .
23-48
6. Reconnectthe battery negative cable.
7. Erase the DTC memory.
8. Read the DTC.
ls DTC 4-3 indicated?
YES Go to step 9.
NO-Shon in the passenger's seat belttensioner;
replace the passenger's seat belt (see page 23-4).1
9. Turn the ignition switch OFF, then disconnect the
battery negative cable, and wait for 3 minutes,