Hid Bulb Removal - Honda S2000 Service Manual

HID Bulb Removal
A transient high tension (25,000 V) occurs at the
bulb sockets of the high intensity discharge (HlD)
lamps when the combination light switch is turned
ON. lt may cause serious electrical shock or
electrocution if you do not observe the cautions
below.
. Never turn on the combination light switch
belore litting the HID bulbs to their bulb sockets
and completing the reassembly ofthe headlight
assemotv.
. Do not service the headlights assembly in wet
conditions, such as rain or snow, near a sprinkler
system. or when your hands are wet to prevent
electrocution.
. Do nottouch the surface ofthe HID bulbs with
your bare hands and do not stain it with anv oils
and fats.
. Do not disassemble the invener unit and the
igniter unit.
. Do not turn on the HID bulb by using a power
source other than the battery mounted in your
vehicle.
1. Make sure you have the anti-theft code for the radio.
then write down the frequencies for the radio,s
preset buttons.
2. Turn the combination light switch OFF.
3. Disconnectthe battery negative cable, then
disconnect the positive cable.
4. Remove the front part of the inner fender as
necessary (see page 20-105).
5. Disconnect 2P connector (A)trom the inverter unit.
Remove the Torx bolt using a tamper-proof Torx
T25 bit.
Turn the cover (B) 45o counterclockwise
to remove
it from the headlight assembly.
7 .
(cont'd)
22-69