Table of Contents
Advertisement
4. Install the self-locking nut and flange nut. and
lightly tighten.
5. Place a jack under the lower arm, and raise the
suspension to load the stabilizer bar.
6. Tighten the self-locking nut 1A) and flange nut (B) to
the specified torque values while holding the
respective joint pins (C) with a hex wrench (D).
1 0 x 1 . 2 5 m m
29 N m (3.0 kgf.m,22 lbf.ft)
7. After 5 minutes of driving. re-tighten the self-
locking nut of the joint connected to the stabilizer
bar again lo the specified torque value.
Lower Arm Removal/lnstallation
Special Tools Required
. Ball joint remover. 28 mm 07MAC-SL00200
1. Raise the rear of the vehicle, and support it with
safety stands in the proper locations
( s e e p a g e 1 - 1 3 ) . R e m o v e t h e r e a r w h e e l .
2. Remove the flange nut (A) while holding the joint
pin (B)with a hex wrench (C). and disconnect the
stabilizer link (D) from the lower arm (E).
A
10 x 1.25 mm
29 N.m (3.0 kgf.m,22lbf.ft)
Remove the flange bolt (A), and disconnect the
damper (B) from the lower arm (C).
(cont'd)
'r-l
18-35
Advertisement
Table of Contents
Troubleshooting
