Honda S2000 Service Manual page 694

10. Adjust clearance "8" as follows:
Push the glass (A) outward 10 mm (0.39 in.), then lightly push the stabilizer (B) against the glass.
Tighten the bolt (C) securing the stabilizer. Check thatthe glass moves smoothly.
Loosen the locknuts (D).
Turn the adjusting bolts (E) until the clearance "8" is within the specified limits. Turn the front and rear
adjusting bolts the same amount to keep the regulator (F) parallel with the seating su rface of the door.
Tighten the locknuts. Make sure that the ends of the adjusting bolts still project out of the locknuts.
Move the glass up and down to seat it, then measure clearance "8" at the designated locations.
Measure clearance "H" again to make sure it is still within the specified limits at the designated locations.
Repeat the above steos until the correct clearance are obtained.
Adiusting Bolt
Top Edge of Glass
Clockwise
-
Moved out
Counter-clockwise
"8" Clearance
- 1
-2
-3
-5
-6
-7
ird
c
8 x 1.25 mm
22 N.n 12.2 kgt m,
16 tbf.ft)
D
8 x 1 . 2 5 m m
12 N.m {1,2 kgf.m,
9 rbf.ftl
(cont'd)
20-13