Cruise Control Actuator Test - Honda S2000 Service Manual

Cruise Gontrol Actuator Test
1. Disconnect the 4P connector from the cruise
control actuator.
Remove the actualor cover.
Connect battery power to the No. 2 terminal of the
4P connector, and connect ground to the No. 1
t e r m i n a l .
Check the magnetic clutch for proper engagement.
A clicking sound should be heard and the output
llnkage should be locked.
lf the output linkage is not locked, replace the
cruise control actuator assembly.
t .
With power and ground slill connected as in step 3,
connect battery power to the No. 4 terminal and
ground to No. 3 terminal, and check that the output
linkage starts to turn from full closed position and
stops at full opened position by the motor in the
actuator.
Reverse power and ground at connector terminals,
No. 4 and No. 3, and check that the output linkage
reverses and stops at the full closed position.
7 .
TRAVEL
lf the output linkage moves sluggishly, or the motor
does not operate properly, replace the cruise
control actuator assemblv.
4-43