Set/Resume Switch Test; Set/Resume Switch Replacement - Honda S2000 Service Manual

Gruise Control
Set/Resume Switch Test
1. Remove the two screws securing the sevresume
switch, then remove the switch.
i
. : -
SET/RESUME
SWITCH CONNECTOR
2 3 4 5
T e r m i n a l s i d e o f f e m a l e t e r m i n a l s
Disconnect the connector from the switch.
Check the set switch for continuity between the
No. 3 and No. 5 terminals of the connector. There
should be continuity while pressing the switch
down, and no continuity when the switch released.
Check the resume switch for continuity between
t h e N o . 1 a n d N o . 3 t e r m i n a l s o f t h e c o n n e c t o r .
T h e r e s h o u l d b e c o n t i n u i t y w h i l e p r e s s i n g t h e
switch down, and no continuity when the switch
reteaseo.
lf either switch is faulty, replace the switch
a s s e m o t y .
lf switch is OK, but switch failure is occurred on the
cruise control unit input test, check and repair the
wire harness on the switch circuit.
6 .
4-42
Set/Resume Switch Replacement
1 . Remove the two screws securing the seVresume
switch, then remove the switch.
Disconnect the connector from the switch.
Replace the switch.
\l
I