Table of Contents
Advertisement
Manual Transmission
Transmission Reassembly (cont'd)
Install the thrust washer (A) and 64 mm spring
washer (B).
69 N.m (7.0 ksf m, 51 lbf.ft)
lnstallthe reverse idler gear (C), mainshaft,
countershaft, and shift fork assemblies (D) with the
snap ring pliers, and set the 68 mm snap ring (E)
into the groove ofthe countershaft bearing.
NOTE: Check that the snap ring is securely seated
in the groove of the countershaft bearing.
Standard:0-6.93 mm (0 -0.273 in.,
Apply liquid gasket (P/N 08718-0001) to the threads
of the 34 mm sealing bolt (F), then install the
34 mm sealing bolt.
4.
13-56
6 . I n s t a l l t h e 1 - 2 s h i f t p i e c e .
lnstallthe select return spring (A) and the 8x40 pin
(B) onto the transmission. then install the interlock
(c).
7 .
Install the shift arm A by aligning the interlock
finger and the shift fork grooves.
Advertisement
Table of Contents
Troubleshooting
