Wiper Motor Test; Washer Motor Test - Honda S2000 Service Manual

Wiper/Washer
1
J
Wiper Motor Test
1. Open the hood and remove the cap nuts and the
wiper arms (see page 22-1'14]-.
2. Remove the hood seal and cowl cover (see page
22-114],.
3. Disconnect the 5P connector from the wiper motor.
Test the motor by connecting battery power and
ground according to the table. lf the motor does not
run or fails to run smoothly, replace it.
Position
Terminal
1
2
4
LOW SPEED
o
@
HIGH SPEED
o o
5 . Connect an analog voltmeter between the No. 5 ( + )
and No. 3 ( ) terminals, and run the motor at low
or high speed. The voltmeter should indicate 0 V
and 5 V or more alternately. lf it does not, replace
the motor,
22-112
-
Washer Motor Test
Remove the right inner tender {see page 20-105).
Disconnect the 2P connector (A) from the washer
m o t o r ( B ) .
Test the washer motor by connecting battery
power to terminal No. 1 and ground to terminal
N o . 2 .
lf the motor does not run or fails to run smoothly,
replace the motor.
1 .