Accessory Power Socket Test/Replacement - Honda S2000 Service Manual

J
Test/Replacement
1 .
2 .
3 .
Remove the rear console (see page 20-78).
Disconnect the 2P connector.
Inspect the connector terminals to be sure they are
all making good contact.
. lf the terminals are bent, loose or corroded,
repair them as necessary, and recheck the
system.
. l f t h e t e r m i n a l s l o o k O K , g o t o s t e p 4 .
WHT/RED
Wire side of female terminals
Turn the ignition switch ACC (l), and check for
voltage between the No. '1 and No. 2 terminals.
. There should be battery voltage.
. lf there is no battery voltage, checkfor:
- b l o w n N o . 9 ( 1 0 A ) f u s e i n t h e u n d e r - d a s h
fuse/relay box.
- faulty accessory power socket relay
- p o o r g r o u n d ( c 4 0 1 , G 6 0 ' 1 )
- a n o p e n i n t h e w i r e .
)
J
4 .
)
A
J
22-95
5. Remove the housing and socket.