Rear Camber Inspection/Adjustment; Front Toe Inspection/Adjustment - Honda S2000 Service Manual

Rear Camber Inspection/Adjustment
Use commerciallv available comDuterized four wheel
a l i g n m e n t e q u i p m e n t t o m e a s u r e w h e e l a l i g n m e n t
(caster, camber, toe, and turning angle). Follow the
equipment manufacturer's instructions.
1. Check the camber angle. lf adjustment is req u ired.
go to step 2.
Rear camber angle:
1"30'+ 10'
2. Hold the adjusting bolt (A) on the control arm, and
loosen the self-locking nut (B).
4 .
54 N.m (5.5 kgf.m,
40 tbf.ft)
Turn the adjusting bolt until the camber is correct.
After adjusting, tighten the self-locking nut while
holding the adjusting bolt.
Front Toe Inspection/Adjustment
U s e c o m m e r c i a l l y a v a i l a b l e c o m p u t e r i z e d f o u r w h e e l
a l i g n m e n t e q u i p m e n t t o m e a s u r e w h e e l a l i g n m e n t
(caster, camber, toe, and turning angle). Follow the
equipment manufacturer's instructions.
1. Centerthe steering wheel spokes.
2 . C h e c k t h e t o e . l f a d j u s t m e n t i s r e q u i r e d , g o t o s t e p
Front toe-in: 0 + 2 mm (0 + 0.08 in.l
3, Hold the tie-rod end (A), and loosen the tie-rod
locknut (B).
33 tbt.ftl
Turn the tie-rod until the toe is correct.
After adjusting, tighten the locknut while holding
the tie-rod end. Reposition the rack-end boot if it is
twisted or dislocated.
(cont'd)
4 ,
5 ,
, . / B
18-7