Table of Contents
Advertisement
Dashboard
Passenger's Side Vent Removal and
lnstallation
1. Wrap a flat-tip screwdriver with protective tape,
and apply protective tape around the related parts
to prevent damage. Carefully insert a flat-tip
screwdriver next to the clip (A), and detach the clips
by prying on the passenger's side vent (B). Take
care not to scratch the dashboard and related parts.
Fastener Locations
A > : C l i p , 2
Remove the vent by releasing the hooks (C).
Reinstall the hook portlons ot the vent first. then
push the clip portions into place securely.
2 .
3 .
/ .-. ---.2- - a
.
'...
.\___t
20-82
Dashboard RemovaUlnstallation
SRS comoonents are located in this area. Review the
SRS component locations (see page 23-9) and the
precautions and procedures (see page 23-10) in the SRS
section belore performing repairs or service.
NOTE:
. When prying with a flst-tip screwdriver, wrap it with
protective tape, and apply protective tape around the
related parts to prevent damage.
. Have an assislant help you when remove and install
the dashboard.
. Take care not to scratch the dashboard, body and
other related parts.
. Put on gloves to protect your hands.
1. Make sure you have the anti-theft code for the radio,
then write down the frequencies for the radio's
Preset buttons.
2. Disconnect the negative cable from the battery, and
wait at least 3 minutes before beginning work.
3. Remove these items:
. Radio panel (see page 20-80)
. Audio unit {see page 20-89}
. Steering column (see page 17-9)
. Passenger's dashboard lower cover {see page
2 0 - 8 1 )
. Front console cover, both sides (see page 20-81)
. Passenger's airbag assembly (see page 23-65)
. Kick panel, both sides (see page 20-69)
. Front pillartrim, both sides (see page 20-68)
Advertisement
Table of Contents
Troubleshooting
