Clutch Master Cylinder Replacement - Honda S2000 Service Manual

Clutch Master Cylinder Replacement
NOTE: Do not spill brake fluid on the vehicle; it may
damage the paint; if brake fluid does contact the paint.
wash it off immediately with water
1. The brake fluid may be sucked out through the top
of the master cylinder reservoir (A) with a syringe.
1 5 N m ( 1 . 5 k g f . m ,
11 tbt.ft)
Disconnect the clutch line (B) from the clutch
master cylinder. Plug the end of the clutch line and
reservoir hose with a shop towel to prevent brake
fluid from coming out.
Pry out the lock pin (A), and pull the pedal pin (B)
out of the yoke. Remove the nuts (C).
4. Bemove the clutch master cylinder (A).
-.--1i:,.'1.
,-_-::-:-:=---_-,;.,1,'a)
Install the clutch master cylinder in the reverse
order of removal. Tighten the master cylinder
m o u n t i n g n u t s t o 1 3 N . m ( 1 . 3 k g f . m , 9 . 4 l b f f t ) .
Bleed the clutch hydraulic system (see step 6 on
p a g e 1 2 - 6 ) .
12-5