Rubber Dams And Fastener Installation, And Primer Application; Molding Installation - Honda S2000 Service Manual

Glass
Windshield Replacement (cont'd)
Rubber Dams and Fastener Installation, and Primer Application
. Be sure the rubber dams and fasteners line up with the alignment marks,
' G l u e t h e r u b b e r d a m s w i t h a d h e s i v e t a p e { N | T T O 5 0 1 l \ i l , o r e q u i v a l e n t ) , a n d g l u e t h e f a s t e n e r w i t h a d h e s i v e t a p e
(3M 4215, or equivalent).
. To glue the molding, apply primer (3M N-200, or equivalent) to the areas between the alignment marks of the
w i n d s h i e l d .
UPPER RUSBER DAM
UPPER CORNER
RUBBER DAM
LOW€R RUBBEB
DAM
LOWER RUBBER
DAM
A L I G N M E N T
MARKS
Apply primer here.
UPPER SEAL
MOLDING
SIDE SEAL
!r
Molding Installation
. B e s u r e t h e a l i g n m e n t m a r k o f t h e m o l d i n g l i n e u p w i t h t h e a l i g n m e n t m a r k o f t h e w i n d s h i e l d .
. G I u e t h e m o l d i n g w i t h a d h e s i v e t a p e ( 3 M 4 2 1 2 , o r e q u i v a l e n t ) .
. G l u e t h e m o l d i n g s e a l s t o t h e m o l d i n g .
ALIGNMENT
M A R K S
A L I G N M E N T M A R K
M O L D I N G
A L I G N M E N T M A R K
MOLDING
ADHESIVE
TAPE
WINDSHIELD
M O L D I N G
13.5 mm {0.53 in.) FASTENER
lrt mm
{0.55 in.)
WINDSHIELD
20-30
WINDSHIELD