Power Mirror Replacement
NOTE: To avoid scratching the door, be sure to hold the
m i r r o r w h i l e r e m o v i n g o r i n s t a l l i n g t h e n u t s .
1. Remove these items:
. D o o r s a s h h o l d e r ( s e e p a g e 2 0 - 1 5 )
. Plastic cover, as necessary (see page 20-2)
2. Disconnectthe connector (A), and detach it from
the door.
Fastoner Locations
4 .
6 x 1 . 0 m m
9.8 N.m
(1.0 kgf.m.7.2 tbt.ftl
Support the mirror (B) with one hand, remove the
nuts (C). then remove the mirror.
Installthe mirror in the reverse order of removal,
and note these items:
. Make sure the connector is plugged in properly.
. Adjustthe position ofthe door sash holder (see
p a g e 2 0 - 1 6 ) .
. Check for water leaks (see step 17 on page 2O-14).
. Test-drive and check for wind noise and rattles.
. When reinstalling the door panel, make sure the
plastic cover is installed properly and sealed
around its perlmeter.
c a : N u r ,
@
,a
o
a
Mirror Holder Replacement
NOTE: Put on gloves to protect your hands-
1. Carefully pull outthe bottom edge ofihe mirror
holder {A} by hand. Take care not to scratch the
mirror.
Separate the mirror holder from the actuator (B) by
slowly pulling them apart while detaching the clips
(C) and releasing the hooks (D).
Reattach the hooks of the mirror holder to the
actuator, then position the mirror holder on the
actuator. Carefully push on the clip portions of the
mirror holder until the mirror holder locks into
prace.
Check the actuator operation.
';';''li1'
) . '
\l
20-21