Doors
1 .
2 .
Door Sash Holder Adjustment
R a i s e t h e g l a s s f u l l y .
L o o s e n t h e l o c k n u t ( A ) w h i l e h o l d i n g t h e a d j u s t i n g
bolt (B) with a hex wrench.
Adjusting Bolt
Top Edge of Holder
Clockwis€
Counterclockwise
A
8 x 1.25 mm
1 2 N . m
(1.2 kgl.m,
9 rbt.ft)
3 . A l i g n t h e d o o r s a s h h o l d e r { C ) w i t h t h e g l a s s u s i n g
the adjusting bolt at the bottom of the door sash
holder, l\4ake sure that there is no clearance
between the end of channel (D) and glass surface.
4. Tighten the locknut securely.
5. Reinstall all remaining removed pans.
6, Check for water leaks (see step 17 on page 20-'14).
7. Test-drive and check for wind noise and rattles.
t
20-16
Door Glass Outer Weatherstrip
Replacement
NOTE:
. Put on gloves to protect your hands.
. Take care notto scratch the door and door molding.
1 . R e m o v e t h e d o o r s a s h h o l d e r { s e e p a g e 2 0 - 1 5 ) .
2. Starting atthe rear, prythe oute r weatherstrip (A)
up, and detach the clips (B, C).
Fastoner Locations
B > : C l i p , 1 C ) : C l i p , 6
lnstall the weatherstrip in the reverse order of
r e m o v a l , a n d r e p l a c e a n y d a m a g e d c l i p s .